For the repair of water level sensor failure, you can try the following steps:
1. Check the power supply and connections: Ensure that the power supply of the sensor is normal, and that the sensor is securely connected to the primary controller or device. Sometimes, a loose connection or power supply problem can cause the sensor to fail.
2. Clean the sensor: If there is dust, dirt or scale on the surface of the sensor, gently wipe the surface of the sensor with appropriate detergent and a soft cloth to ensure that the sensor can receive signals normally. However, before cleaning, make sure to disconnect the power supply to avoid the risk of electric shock.
3. Calibrate the sensor: Some water level sensors may need to be calibrated to ensure accurate readings. You can refer to the sensor's manual or the manufacturer to learn how to perform calibration operations.
4. Replace the sensor: If the fault cannot be repaired after the above steps, it is likely that the sensor itself has a problem. At this time, it is best for the manufacturer or professional and technical personnel to understand the specific operation and precautions for replacing the sensor.
This article illegal climbing is taken from experience