Whether it is pasted wood veneer, PVC or pre-painted paper, pay attention to whether the leather is pasted flat, and whether there is bulging, foaming, and lax stitching. Look at the light when you check. You can't tell if you don't flush. Ash veneer furniture is relatively easy to damage, generally only two years. As far as wood veneers are concerned, planed veneers are better than rotary ones. The way to identify the two is to look at the pattern of the wood, the grain of sliced veneer wood is straight and dense, and the pattern of rotary cut veneer is curved and sparse. Particleboard veneer furniture, the landing part must be sealed, not sealed edge board will absorb moisture, rise and damage. General veneer furniture corners are easy to tilt up, you can pick the corner with your hand, if a pick up, it shows that there is a problem with glue.
Tip 1: Check whether the installation of accessories is reasonable, such as checking the door lock switch is not working; The large cabinet should be equipped with three dark hinges, and some can not be installed only two; The three screws, some cut corners, only on a screw, will be used.
Tip 2: Mirror furniture to check the back of the selection of furniture with mirrors, such as dressers, clothing mirrors, clothing mirrors, pay attention to take a look, see if the mirror is deformed, check whether the mercury at the back of the mirror is lined paper and backplane, no backplane is unqualified, no paper is not good, otherwise it will wear off the mercury.
Tip 3: Sofa, soft bed to try to sit on the sofa, soft bed, should pay attention to the surface to be flat, not uneven; Soft and hard to be even, not this hard, that soft; The hardness should be moderate, neither too hard nor too soft. The selection method is to sit down, press a press with the hand, flat, the spring does not ring, if the spring layout is not reasonable, resulting in the spring bite spring, it will make a sound. Secondly, attention should also be paid to whether the quilting has broken lines, jumpers, and whether the density of the corner teeth is reasonable.