Digital China's DCWS-6028 wireless controller and DCWL-7942AP set up the wireless network.
DCWS-6028 wireless controller one
One DCWL-7942AP
One PC
One Console cable
A terminal software
Two network cables
One wireless power supply module
This content has been taken from experience without authorization
3. After the login, press the following code to set VLAN1 as the management VLAN and VLAN2 as the user VLAN. Enable the DHCP address pool function, and set network segment 192.168.1.0 as the management segment and 192.168.2.0 as the user network segment. vlan 1exitvlan 2exitin vl 2sw mo trip add 192.168.2.1 255.255.255.0no ship dhcp pool GLnetw 192.168.1.0 255.255.255.0default-router 192.168.1.1exitip dhcp pool Clientpoolnetw 192.168.2.0 255.255.255.0default-router 192.168.2.1 exitwirelessenable
4. Check whether the AP is online. The online process can be long or short. If no AP is connected after 2 minutes, check whether the AP is correctly configured or whether the network cable is correctly installed. If it is successfully launched, you can view it in show wir ap st. If it fails, it is displayed in show wir ap fai st. If it fails, you can manually add it to the database. To view the value, run the show wir ap st command. Then tap the command wirelessnetwork 1ssid WIFI-Freesecurity mode nonevlan 2. Enter the wireless configuration mode and network 1 configuration mode with the network name as follows: The wifi-free encryption type is not encrypted (this refers to open WIFI, anyone can connect), and the user goes to VLAN2 to obtain an IP address.
5. View the AP hardware number, bind the AP hardware number to profile1, and deliver the configuration. Type the following command: show wir ap stshow wir ap (the MAC address displayed in show wir ap st) statusHardware Type indicates the hardware number bound to the hardware version item. ap profile 1hwtype 5 (The number here is your AP hardware number) Bound commands are performed in wireless mode.
6. Send the configuration file to the AP to make it work. endwir ap prof a 1y Run the following command to check whether the configuration delivery is successful or complete: show wir ap st If the value of Status In Progress is: In Progress Success is: Success If the value is not the two items, you should know that it fails. OK, I got it here. Let's test it out.
7. Test whether the network is available: I used my wireless card to search for the network signal: because no password was attached to it, anyone can connect to it. OK, the connection is successful!
Wireless controller configuration
The network cable is correctly inserted.